Wind Machines for Minimizing Cold Injury to Horticultural Crops
Table of Contents
When plant tissue temperatures fall below critical values, sensitive perennial crops such as grapevines and tender tree fruits can suffer irreversible cold injury, causing malfunction or death of plant cells. One protection method is to use wind machines, which became widely used in Niagara for grapes in the late 1990s. Today there are almost 500 in Ontario. A four-year, on-farm research project conducted in Niagara to establish best management practices for wind machines and find more effective ways to use them ended in Fall 2009.
Wind Machines in a Vineyard or Orchard
Wind machines are tall, fixed-in-place, engine-driven fans that pull warm air down from at least 15 m above ground during strong temperature inversions, blowing it down and out, pushing away and replacing cold air near target crops. This raises air temperatures around cold-sensitive perennial crops such as grapes (Figure 1). Wind machines are not the same as wind turbines, designed to create electricity from wind energy.
Figure 1. Using wind machines is one method of protecting horticultural crops from cold injury.
Wind machines break up micro-scale air boundary layers over plant surfaces, improving sensible heat transfer from the air to the plants. Wind machines transfer heat by forced convection. While the blades spin, the head of the fan rotates around the tower's vertical axis. Air circulates north, east, south, west, then north again 4.56.5 min later, depending on the machine type (Figure 2). The area protected covers 35 ha, depending on topography, field layout, strength of temperature inversion, time of year and drift due to slight winds. If a wind machine completes this circuit too slowly, cold air can resettle or drift in from cooler areas upstream or upwind of the machine, resulting in crop injury. It doesn't take long for crop damage to occur at critical air temperatures.
Figure 2. Wind machines pull warm air down from high above a field, blowing it downward and outward, pushing away cold air near target crops and replacing it with warmer air.
Temperature inversions are strong when air temperatures 20 m above the field are at least 3°C warmer than at crop level about 0.625 m above ground. Strong, night-time radiative temperature inversions occur during periods when wind machines might be used in Niagara when skies are clear and starlit, but with minimal wind movement. Temperature inversions of up to 10°C were observed during the research project.
For inversions to form, wind speeds must be less than 7 km/h; for inversions to break up, wind speeds must be greater than 7 km/h. This is because the wind mixes the air above the field with the air at ground level. This is like a house furnace fan mixing air throughout a house to keep air temperatures more uniform. When that fan is off, air stratification can occur with colder, heavier air settling in the basement, while warmer, lighter air rises and remains upstairs. Wind machines can raise air temperatures around plants by about a third to half the temperature inversion difference.
Field air temperatures are often very different from local or regional forecasts. Forecasts don't predict air temperatures close to crop levels or low areas where air temperatures are often colder. Air temperatures can drop abruptly many degrees in an hour, often at sunset or sunrise, so predicting exactly if and when to operate a wind machine can be difficult.
The effect on air temperatures near the ground is almost instantaneous after a wind machine is turned on, but air temperatures will vary slightly throughout the area. See Table 1. Note a strong temperature inversion of 4.8°C at 2:25 am just as the wind machine started (6.21.4 = 4.8°C), while air temperatures 20 m above the vineyard remained almost constant, indicating what might be considered an ocean of warm air high above the field.
There was a slight 45 km/h southwesterly wind causing air temperatures to rise higher on the northeast (downstream) side of the wind machine, while air temperatures rose more slowly on the southwest (upstream) side of the wind machine. The area protected by a wind machine is affected both by topography and by wind direction and speed, since cold air flows down slope like cold molasses.
Many neighbours do not like wind machine noise. Machines need large engines operating at high RPMs and long-pitched blades to blow air a long distance, so it is difficult to design them to be quieter. Sound comes from the engine and the blades. Because wind machines make a 360° sweep around the tower over a few minutes, sound oscillates in intensity in a sinusoidal fashion. Some find this irritating, since it makes them wait in anticipation for the sound to grow louder (Figure 3).
Figure 3. Neighbours hear wind machine sound as varying sinusoidally as blades sweep around the field. Sound is greatest when blades blow away from a receiver (neighbour), next greatest when blowing at a receiver. If air is blowing perpendicularly, the sound is greatly reduced.
Slower blade speed reduces noise, but reduces airflow, so more machines are needed to cover the same area.
Unfortunately, it is generally very quiet in rural areas at times when wind machines operate during the spring, fall or winter nights when there are few, if any, other noises, such as wind or cars, to mask the sound. Conditions outside also complicate and affect sound movement from wind machines by:
Conditions inside homes that complicate and allow external sound waves to penetrate or be amplified include large rooms, large windows, hard floors and light construction. Wind machine sound is generally quieter and less offensive in small carpeted rooms with heavy thick walls and in house areas opposite to the side where a wind machine is, or in basements. The sound is sometimes partially masked inside a house if there is white noise present, such as from a radio, television or ventilation fan.
Wind machine blades produce low frequency infrasound waves that travel long distances and may penetrate building components of residential structures. Low frequency sound is like low bass music sounds you might hear in your home when someone next door is playing their stereo, even though you cannot hear the rest of the music.
Farmers are protected from nuisance noise complaints by neighbours provided they follow normal farm practice. Normal farm practice can only be determined by the Normal Farm Practices Protection Board, a quasi-judicial administrative board of non-government members, appointed by the Ontario Government under the Farming and Food Production Protection Act (FFPPA).
The FFPPA, 1998, defines normal farm practice as one which:
Grape growers should employ the following best management practices for operating wind machines to use them more effectively and minimize nuisance noise.
Location of Wind Machines
For more information:
Toll Free: 1-877-424-1300